LESSON 3
REMOVE AND REPLACE DEFECTIVE MODULES
3-1.
GENERAL
When X-ray system failures occur, they must be corrected. Correcting
malfunctions often makes it necessary to remove system parts or assemblies in order to
gain access to the faulty components. The information in this lesson will assist you in
the correction of malfunctions by providing instructions for the replacement of defective
parts.
3-2.
HAND TOOLS REQUIRED
a. Slot-head screwdrivers (including a small-blade pocket screwdriver).
b. Number one and Number two Phillips-head screwdrivers.
c. Needle-nosed pliers.
d. A set of SAE open/box-end wrenches or a six-inch (150mm) adjustable
wrench.
e. An inspection mirror.
f. Wiring labels.
g. A shorting bar.
h. A set of hex-key wrenches.
i. A spirit level.
LocTiteTM number 232.
j.
NOTE:
It is recommended these procedures be performed only by a qualified medical
equipment repairman.
3-3.
components discussed in this part of the lesson.
MD0351
3-2