(d) Ignite the torch.
(e) Point the flame at the center of the overlapping joint. The blue tip
of flame should be about 1/8 inch from the joint. This will heat both pieces of tubing
equally.
(f) Move the flame around the joint and touch the solder to opposite
side of the flame. The solder will melt and flow around the joint when the joint is hot
enough.
(g) Extinguish torch.
(h) Obtain a professional appearance on the soldered joint by wiping
the joint with a wet rag to cool the joint and remove the flux.
1-6.
THERMOSTAT REMOVAL AND REPLACEMENT
a. Unplug the unit.
b. Open the door.
c. Locate the thermostat.
d. Remove the knob.
e. Remove the faulty thermostat.
f. Replace the faulty thermostat with a thermostat that functions.
g. Replace the knob.
h. Close the door.
i. Plug in the unit.
1-7.
THERMAL OVERLOAD DEVICE REMOVAL AND REPLACEMENT
a. Unplug the unit.
b. Locate the thermal overload detector.
c. Remove electrical connections.
d. Remove the malfunctioning thermal overload detector.
MD0367
1-11