3.
You are performing the general safety precautions before disassembling the
monitor. Which task do you perform?
a. Rotate the monitor into an upright position.
b. Remove the monitor chassis from the base.
c.
Set the supply voltage to 12v.
d. Remove the output cable.
4.
You check the NiCad battery charger when you calibrate the monitor. You
disconnect the battery from the charger and substitute a resistive load of:
a. 40ohms.
b. 55ohms.
c.
60ohms.
d. 75ohms.
5.
You are calibrating the ground analog amplifier. Which of the following is included
a. Battery meter.
b. Vertical amplitude.
c.
Delayed analog signal.
d. Chart recorder amplitude.
6.
You are calibrating the nonfade circuit. Which task do you perform during this
a. Calibrate the high voltage.
b. Check and adjust the linearity.
c.
Adjust the low battery cutoff circuit.
d. Calibrate the heart rate meter and alarm.
MD0362
1-27