4.
You are following general safety precautions while working on the hyfrecator. If you
do not remove the F1 fuse, you:
a. Connect the hand piece.
b. Depress the hand switch.
c.
Connect the foot switch cables.
d. Turn down the power to a safe level.
5.
Which of the following do you perform as part of the quarterly PMCS procedures?
a. Remove the printed circuit board.
b. Measure for voltage integrity.
c.
Remove the operative assembly.
d. Perform an operational checkout.
6.
You are performing an operational checkout. You should hold the needle electrode
two to three millimeters away from which item?
a. Wet sponge.
b. Hand switch.
c.
Switch control cord.
d. LOW output receptacle.
7.
The specification for both BIPOLAR outputs is:
a. 20 + 2 watts (500 ohm load).
b. 30 + 2 watts (500 ohm load).
c.
30 + 4 watts (500 ohm load).
d. 40 + 2 watts (500 ohm load).
MD0363
1-13