EXERCISES, LESSON 4
INSTRUCTIONS: Answer the following exercises by marking the response that best
answers the question.
After you have completed all of the exercises, turn to "Solutions to Exercises" at
the end of the lesson and check your answers. For exercises answered incorrectly,
reread the material referenced after the solution.
1.
The last step in removing and repairing or replacing a component of the
a. Drain the storage tank.
b. Rinse the intake silencer.
c.
Perform an operational checkout.
d. Ensure the air relief valve push button is functioning.
2.
The flow control valve can be disassembled, cleaned, and reassembled. When
doing this inspection, how many O-rings are required for proper functioning?
a. One.
b. Two.
c.
Three.
d. Four.
3.
When reassembling the compressor, the cylinder head clearance between top of
casting and piston must be between which of the following?
a. 0.005 inches and 0.009 inches.
b. 0.010 inches and 0.016 inches.
c.
0.017 inches and 0.020 inches.
d. 0.021 inches and 0.030 inches.
MD0366
4-15