s. Replace the toe board cover, motor cover, and plastic toe cover.
t. Install the chair on the lift using the bolts, washers, and nuts you removed in
step e. above.
u. Connect the chair power cord to the connector at the front of the lift.
v. Raise the bellows cover and attach to the bellows hanger with the number ten
screws you removed in step d. above.
w. Connect to the external power supply.
x. Using the foot control, lower the chair.
y. Check the automatic controls as follows.
NOTE:
Make sure the toggle switch on the junction box located under the chair is in
the AUTO position. Refer to figure 3-12.
Figure 3-12. View of toggle switch on junction box.
MD0373
3-18