(4)
Inspect the exterior surfaces and door hinges for the following
conditions.
(a) Loose or missing parts.
(b)
(c)
Corrosion.
(d) Ensure all name plates and warning labels are present, legible and
securely mounted.
(5)
Perform a table operations check.
(a) Press and hold the longitudinal foot switch until the top reaches its
limit of travel. The table top should move approximately 30 inches from the center
position before stopping.
(b) Press and hold the longitudinal head switch until the table top
reaches its limit of travel. The table top should move approximately 30 inches from the
center position before stopping.
(c) Press and hold the table center switch until the table top stops. It
should move to the center position, from either of the two longitudinal positions before
stopping.
(d) Press and hold the Trendelenburg tilt switch until the table reaches
its maximum tilt. The table top should tilt 12 degrees down toward the head end and
stop.
(e) Press and hold the vertical tilt switch until the table top reaches the
maximum tilt. The table should tilt 88 degrees down toward the foot end before it stops.
(f) Engage all the locks and attempt to reposition the spot film device
in all directions. It should take a minimum of 20 pounds of force to move a
corresponding part. The locks should not make a banging sound when engaged.
A faulty lock can cause serious injury. A system with malfunctioning
CAUTION:
locks should be taken out of service.
c. Inspect Tubestand.
(1)
Inspect all exterior painted and plated surfaces for the following
conditions.
MD0351
1-4
Previous Page
