(22) Reinstall the chair and secure it to the lift with the screws, lock washers
and the nuts removed in step (4) above.
(23) Run the lift up to its two extreme positions with one person in the chair.
Take care when running the lift down so that it does not crush the
CAUTION:
bellows cover. Recheck the clearance between the pantograph arms in
the lower position. There should be at least 5/8 inch clearance.
Readjust as required.
(24) Adjust the automatic exit position (Switch "B" in figure 3-7) to the desired
position as described in step (17) above.
(25) Run the lift one-half way down and secure the bellows cover to the
bellows hanger with the screws removed in step (1). Refer to figure 3-3.
b. Chair Is In DOWN Position and Will Not Raise.
(1)
Remove the chair and cover as stated in procedure a. above, steps (1)
through (7).
(2)
Remove the screw and the cord clamp which secures the chair power
coil cord.
(3) Remove the four 5/16 inch hex-head bolts which secure the upper roller
guide to the chair mount casting. While removing each bolt, be very careful not to get
the four adjustment nuts and the sleeves mixed up or change the adjustment. You must
place these back in the same order in which you removed them.
(4) Remove the upper roller guide from the lift assembly and the lift chair
mount casting and swing it over and out of the way for removal of the gear motor.
(5)
Use a 5/16 inch Allen wrench to remove the three motor mounting
screws.
(6)
Remove the screw which secures the limit switch cover and lift the cover
out.
(7) Ensure that the limit switch cover is off, then slide the gear motor
forward and lift up to disengage the chain from the sprocket.
(8) Ensure that the chain is disengaged from the sprocket and lift up on the
lift assembly (a helper will be required). The lift can then be raised to its full extended
up position.
MD0373
3-10