29.
How close do you put the fluoroscopic assembly to the test pattern?
a. Raise the assembly to the maximum.
b. Raise the assembly to 15 inches from the test pattern.
c.
Lower the assembly to 12 inches from the test pattern.
d. Lower the assembly to just touch the test pattern.
30.
Which of the following items is used to perform the exposure rate test?
a. Lead numbers for identification.
b. Sponges or a 12-inch spacer.
c.
One metallic object 3 inches long.
d. A direct readout dosimeter.
31.
Where do you place the answer to exercise 10?
a. On the upper right quadrant of the image.
b. On the lower right quadrant of the image.
c.
32.
The exposure rate should be measured:
a. Upon the implementation of a quality assurance program.
b. When new equipment is installed.
c.
Routinely at 6-month intervals.
d. All of the above.
Check Your Answers on Next Page
MD0062
5-22