NOTE:
Both TOE and tables of distribution and allowances (TDA) units use the DA
Form 2407. Its use is advantageous for TDA units to account for manhours.
(l) Block 20h, National stock number. Enter the NSN or part number
for each part, component, or assembly in column 20c. Leave blank for adjustment or
when NSNs or part numbers cannot be identified.
(m) Block 20i, Part source code. Place a mark in this column only if the
part came from cannibalization.
(n) Block 20j, Qty. Enter the total number of parts required to
accomplish the task.
(o) Block 20k, Parts cost. Enter the cost of each part.
(p) Block 20l, Total manhours. Enter the total number of manhours
required in hours and tenths.
(q) Block 20m, Total manhours cost. Leave this block blank (local
option).
(r)
Block 20n, Total parts cost. Enter the total cost of all parts
installed.
(s) Block 21, Delay. Place a mark in the appropriate box. If no delay
occurred, leave it blank.
(t) Block 22, Data transcribed. Place a mark in this box only when the
information has been transferred to another form (DA Form 2409).
(u)
Block 23, Submitted by. Previously entered.
(v) Block 24, Received by. The person receiving the request signs this
block and enters the Julian date.
(w) Block 25, work started by/Julian date. The person starting the job
signs this block and enters the Julian date.
(x) Block 26, inspected by/Julian date. The person inspecting the work
signs this block and enters the Julian date.
(y) Block 27, accepted by/Julian date. The person accepting the
equipment for the owner signs this block and enters the Julian date.
(z)
Block 28, disposition. Place a mark in the appropriate box.
MD0358
1-18