(ad) Block 23, Submitted by. Refer to figure 1-8. The person submitting
the DA Form 2407 signs in this block and enters the Julian date.
(ae) Block 24, Received by. Refer to figure 1-8. The person receiving
the request signs in this block and enters the Julian date.
(2) Work accomplished by support maintenance. The unit performing the
work checks the entries in Section I and fills in Section II. Refer to figures 1-6, 1-8, and
1-9.
(a) Block 16, Describe deficiencies or symptoms on the basis of
complete checkout and diagnostic procedure in equipment TM. (Previously filled in.)
(b) Block 16a, Remarks.
1 This block is used to note any items listed, but not received, and
show the status of equipment. Note any NMCM and NMCS time for items reportable on
the DA Form 2406 here. Components and subsystems of reportable items will also
have NMC time noted. The starting and stopping days for both NMCM and NMCS are
also shown. You do not need this information if you are under an automated system
which collects NMC time for you.
2 When the item in block 3 needs "onsite" or "deferred" repairs,
explain that. Make the applicable entry from those shown in paragraph 1-3c(1)(ac)4
above for onsite or deferred work.
NOTE:
Block 24 is filled in only when the onsite repair is started or the deferred item is
brought back.
(c) Block 17a, Repair organization/activity. Enter the designation of the
unit or activity doing the work.
(d)
Block 17b, Location. Enter the location of the unit or activity doing
the work.
(e) Block 17c, Unit identity code. Enter the DODAAC of the
organization listed in 17a.
(f) Block 18, Type organization/activity accomplishing work. Place a
mark in the appropriate block.
(g) Block 19, Army management structure (AMS) account code. Leave
blank.
(h)
Block 20a, Act code. Leave blank.
MD0358
1-16