j. Dryer Sensor Problem. If you must remove the dryer sensor, use the
following procedures:
(1) Disconnect power. Remove the leads from the dryer sensor at TS3.
Remove the lift-out dryer and lift-out rack.
(2) Remove the four screws securing the cover on the front heater. Drop
the cover down to expose the heater components.
(3)
Loosen the clamp securing the sensor and slide out the sensor.
(4) After installing a new sensor, perform the "temperature calibration"
described in Lesson 3.
Section II. X-OMAT X-RAY FILM PROCESSOR
4-6.
GENERAL
In order to properly maintain the X-OMAT X-ray film processor, you must be
familiar with its theory of operation. You must also know how to remove and replace or
repair a malfunctioning component. The following procedures are examples of the
methods to use to correct common malfunctions. For further information on removing
and replacing or repairing defective components of the X-OMAT refer to the
manufacturer's service manual. Refer to figure 4-10 for a pictorial representation of the
electrical sequence of operation and figure 4-11 for a circuit diagram of the X-OMAT.
MD0359
4-22