REMOVE AND REPLACE OR REPAIR DEFECTIVE COMPONENTS--X-OMAT
4-7.
a. Wash Rack Assembly Chain Tension Problem. The chain on the wash
rack assemblies is loose. To adjust it, use the following procedures.
(1)
Loosen the four holding screws.
(2) Rotate the four adjusting screws clockwise to increase the tension (or
counterclockwise to loosen the tension).
(3)
Tighten the four holding screws.
(4) If the chain is too loose with maximum adjustment, remove a link. Refer
to figure 4-12.
Figure 4-12. Wash rack assembly.
MD0359
4-25