4.
You are using the troubleshooting guide (refer to the appendix) to isolate the
cause of a malfunction. The lateral controls are not operable. What is the probable
cause of this malfunction?
a. Transfer rod is not secured with set screws (figure 1-8).
b. Worm gear in the column assembly is worn or stripped (figure 1-10).
c.
Female left crank adapter is stripped (figure 1-8).
d. Female adapter collar is stripped (figure 1-7).
5.
You are using the troubleshooting guide (refer to the appendix) to isolate the
cause of a malfunction. What would probably cause the back to get stuck in the
lowest position and not rise?
a. The square key (Part 41) is sheared or missing (figure 1-5).
b. The square key (Part 31) is sheared or missing (figure 1-5).
c.
The set screw (Part 39) is missing (figure 1-5).
d. The female left crank adapter is stripped (figure 1-8).
6.
You are replacing the head section. Before you withdraw the head section from
the mount holes, you:
a. Loosen the clamp knobs on the underside of the back section.
b. Depress the release plungers of the locking posts.
c.
Loosen the two set screws located underneath.
d. Adjust the table vertically.
MD0370
1-32