14.
You would call a service representative or engineer if the retest reveals:
_____________________________________.
_____________________________________.
_____________________________________.
_____________________________________.
Exercises 15 through 19 pertain to the cut thickness test.
15.
To perform the cut thickness test you need a 45-degree tomographic wedge with
a ____________________________ ________________________.
16.
Select the most commonly used tomographic motion, sweep speed, and
____________________________ ________________________.
17.
Select a cut level of ___________________.
18.
As the exposure angle increases, the thickness of the cut plane should
_________________________.
19.
The cut thickness test should be performed every ____________months.
Exercises 20 through 24 pertain to the flatness of plane test.
20.
What size cassette is used to perform the flatness of plane test?
__________________________________________________.
21.
Set the control panel at ___________kVp and __________mAs approximately.
22.
How many test films are photographed for the flatness of plane test? _________
23.
To evaluate the test films, you place them on the _________________________.
MD0062
6-29