9.
What do you use to remove roughness from guide shoes?
a. Warm water, not to exceed 110 degrees F.
b. Mildly abrasive cleaner such as Ajax.
c.
Plastic abrasive material such as Scotch-Brite.
d. No. 400 sandpaper.
10.
Which of the following procedures do you use if you find that the pulley sleeve is
not secure to the pulley?
a. Tighten the set screw holding the sleeve to the pulley.
b. Replace the pulley sleeve.
c.
Cement the pulley sleeve to the pulley.
d. Tighten the belt so the sleeve is held to the pulley.
11.
How often do you change the developer recirculation system filter?
a. Weekly or after feeding 500 films, whichever comes first.
b. Monthly or after feeding 5,000 films, whichever comes first.
c.
Monthly or after feeding 1,000 films, whichever comes first.
d. Yearly or after feeding 5,000 films, whichever comes first.
12.
At what temperature does the manufacturer set the developer thermostat?
a. 85F.
b. 90F.
c.
95F.
d. 150F.
MD0359
2-28