(3) Wipe stainless steel feed rollers and check that they turn freely and then
reinstall crossovers.
(4)
Clean the dryer rollers.
(5)
Flush out sink below solution tanks.
(6)
Wipe up chemical deposits on machine.
(7)
Turn off wash water.
(8) To prevent rusting, leave dryer and processor covers open slightly when
machine is not running.
e.
Standby Position.
(1) To allow for emergency work at night or during other slack periods, leave
only heat and cool switches on. Then, when other switches are turned on, machine will
be ready for processing within 10 minutes.
(2)
Also leave the valve(s) open in the cold water supply line to heat
exchanger.
(3)
To save time, turn other switches on before exposing film.
f. Clearing a Film Jam.
(1)
Sheet film.
(a) Leave power on.
(b) Remove crossover ahead of pile-up.
(c) Remove film at this point to avoid further pile-up. Put films in a tray
of water to prevent them from sticking together.
(d) Clear the film jam. Turn off circulation if a rack is removed.
(e) Feed the removed films into the rack nearest the point of jamming
to complete cycle.
(f)
Determine the cause of the jam and correct it.
(2)
Roll film.
(a)
Shut off the power.
MD0954
3-6