┌─────────────────┬───────────────────┬─────────────────────────┐
│ Problem
│ Potential Cause
│ Corrective Action
│
╞═════════════════╪═══════════════════╪═════════════════════════╡
│
│
│ not calibrated to │ in step (b).
│
│
│ zero.
│
│
│
│
OR
│
│
│
├───────────────────┼─────────────────────────┤
│
│ Malfunction in the│ 5. Remove the bypass
│
│
│ bypass valve.
│ valve so you can take it│
│
│
│ apart. Use a 1/2 inch
│
│
│
│ and 5/8 inch wrench to │
│
│
OR
│ open the valve. Remove │
│
│
│ valve seat (P/N 2867)
│
│
│
│ and check condition of │
│
│
│ rubber disk (P/N 2877) │
│
│
│ and O-ring (P/N 2838). │
│
│
│ Replace if cut, flat or │
│
│
│ worn. Replace spring
│
│
│
│ (P/N 2839) if corroded. │
│
│
│ Rotate adjuster screw
│
│
│
│ (P/N 4227) fully clock- │
│
│
│ wise to remove. Replace │
│
│
│ O-ring (P/N 274) if
│
│
│
│ worn, cut, or flat.
│
│
│
│
│
│
│
│
OR
│
│
│
├─────────────────────────┤
│
│
│ 6. Replace bypass valve │
│
│
│ (P/N 4225).
│
│
├───────────────────┼─────────────────────────┤
│
│ Worn O-ring (P/N │ 7. Use 1/2 inch open-end│
│
│ 114) on end of
│
│ nebulizer valve. │ Replace O-ring if cut, │
│
│
│ flat, or worn.
│
└─────────────────┴───────────────────┴─────────────────────────┘
Table 2-4. Flow system troubleshooting (concluded).
Figure 2-3. Cam stop.
MD0355
2-12