15.
When checking for film switch activation on the AFP 14-X3 X-ray Film Processor,
which of the following statements is true?
a. When measuring voltage, you should get a reading at TP5 and TP1 on
PCB J2 of 12vdc when you release the film switch.
b. When measuring resistance, you should get a reading of infinite ohms when
you depress the film switch.
c.
When measuring the voltage, you should get a reading at TP5 and TP1 on
PCB J2 of 12vdc when you depress the switch.
d. When measuring resistance, you should get a reading of 0 ohms when the
switch is released.
16.
What are the three timers on the AFP 14-X3 X-ray Film Processor timing PC
board J2?
a. The cycle, power, and line timers.
b. The jog, audible signal, and feed timers.
c.
The temperature, developer, and film switch timers.
d. The cycle, jog, and feed signal timers.
17.
What is the purpose of the jog function with the AFP 14-X3 X-ray Film Processor?
a. To ensure that the dryer blower turns on at the appropriate time in the
processing cycle.
b. To activate the drive motor and wash solenoid periodically when the processor
is on but not processing film.
c.
To ensure no circulation occurs when the processor is on but processing is
not occurring.
d. To heat and cool the developer and dryer heaters alternately.
MD0359
1-43