9.
Which of the following is the first step for removing the developer tank heater on
the X-OMAT X-ray Film Processor?
a. Remove the inlet and outlet hoses from the heater.
b. Disconnect the power from the unit.
c.
Locate the developer tank heater.
d. Remove the electrical connection.
10.
Refer to the figure below. What number identifies the replenisher pump?
a. 1.
b. 2.
c.
3.
d. 4.
11.
Which of the following is a procedure for removing and replacing the X-OMAT
X-ray Film Processor's developer replenishment pump?
a. As the first step, locate the replenishment pump.
b. Remove the outlet arm inlet hose.
c.
Always replace the O-ring.
d. Replace pump assembly before you replace the pump.
Check Your Answers on Next Page
MD0359
4-33
Previous Page
