24.
The tomographic cut plane should be flat to within plus or minus ________mm.
Exercises 25 through 29 pertain to the resolution test.
25.
Select the cut level of ____________cm to perform the resolution test.
26.
Set the control panel at ___________kVp and __________mAs approximately to
perform the resolution test..
27.
In addition to the tomographic motion, sweep speed, and exposure angle, the
data form should include: (List two)
_______________________________________.
_______________________________________.
28.
The mesh will be in focus at the level of the cut plane.
a. True.
b. False.
29.
The resolution test should be performed every _____________months.
30.
Concerning the cut level test, what is another phrase for "cut level?"
_____________________________________________________.
31.
The attenuator blocks in the cut level test are made of _____________________.
32.
To interpret the film in the exposure angle test, where do you place the film?
______________________________________________________.
33.
The exposure angle test must be performed every ___________months.
MD0062
6-30