Figure 1-13. DA Form 2406, block 9.
(c) Block 9b(2), Effect-on-System. Enter the appropriate EOS code
(following the noun). The EOS block may contain one or two alpha characters or may
be blank.
(d) Use the EOS code to highlight the subsystem when a system is
NMC because an authorized subsystem is not on-hand.
1 Use EOS codes for systems falling below 100 percent FMC.
2 List the requisition number for the subsystem on the back of the
DA Form 2406.
3 Ask the supporting AMC LAO for assistance with the requisition.
(e) Use the table shown in figure 1-14 to determine which codes to
use.
(f) Use up to two codes if more than one subsystem causes problems.
Make a separate column by drawing a line down the form 3/8-inch from the right-hand
edge of column 9b(1).
MD0358
1-26