(2)
Disconnect the monitor from the ac line.
(3)
Remove the patient cable.
(4)
Remove the output cable.
b. Access the Monitor Main Circuit Board.
(1)
Remove the two front screws holding the base to the monitor chassis
(figure 1-6).
(2) Loosen the two rear screws to function as a hinge for easy access to the
circuit boards.
(3)
Rotate the monitor into an upright position (figure 1-7).
Figure 1-6. Monitor circuit board access.
Figure 1-7. Monitor chassis in fully open
position.
c. General Safety Precautions. Perform the following before disassembling the
defibrillator/cardioscope:
(1)
Turn off the defibrillator module.
(2)
Remove the line cord.
(3)
Remove the paddle set.
MD0362
1-9
Previous Page
